# Babel diode is overheating

**URL:** <https://forum.zubax.com/t/babel-diode-is-overheating/947>\
**Category:** Cyphal & DroneCAN\
**Created:** [April 28, 2018, 1:25am UTC](https://forum.zubax.com/t/babel-diode-is-overheating/947 "2018-04-28T01:25:13Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![scottdarch](https://forum.zubax.com/user_avatar/forum.zubax.com/scottdarch/32/164_2.png) [@scottdarch](https://forum.zubax.com/u/scottdarch)\
**Post date:** [April 28, 2018, 1:25am UTC](https://forum.zubax.com/t/babel-diode-is-overheating/947/1 "2018-04-28T01:25:13Z")

</div>

This part (diode?) started to overheat on my babel :

 ![bad%20part](https://forum.zubax.com/uploads/default/original/1X/ef9be55b7831e25d58f32ceeb45b55c295232e9c.jpg)  
I’m not sure what I did to damage it but the board seems functional otherwise (as long as I don’t keep it plugin in for too long). Can you tell me what this part is so I can order a replacement from Digikey?

---

<div class="post-metadata">

**Author:** ![alexander.sysoev](https://forum.zubax.com/letter_avatar_proxy/v4/letter/a/da6949/32.png) [@alexander.sysoev](https://forum.zubax.com/u/alexander.sysoev)\
**Post date:** [April 30, 2018, 11:01am UTC](https://forum.zubax.com/t/babel-diode-is-overheating/947/2 "2018-04-30T11:01:28Z")

</div>

The diode in your pic is [CRS08](https://www.digikey.com/products/en?keywords=CRS08QMCT-ND)  
Its only purpose is to prevent current flow into usb connector.  
Basically it can be replaced with any low-drop diode in SOD-123 package(like [MBR0520](https://www.digikey.com/product-detail/en/on-semiconductor/MBR0520LT1G/MBR0520LT1GOSTR-ND/918574)).  
But I bet this won’t help your Babel, as the only reason for this diode to heat up is abnormal power consumption on 5V line. This may happen due to a short somewhere or PCB contamination(which causes a short), its hard to say remotely. But just in case clean your babels with alcohol.  
Also you should check the voltage on 5V line. Here is where it can be found.

 ![image](https://forum.zubax.com/uploads/default/original/1X/1d393efcf674b1c11a74e3ef4430958f6cbab217.png)

Best regards, Alex
